Welcome, Guest. Please Login or Register
Stick and Tissue Logo
 
  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
Hot Bending Info (Read 600 times)
Reply #3 - Mar 27th, 2018 at 10:03pm

Sky9pilot   Offline
Administrator
Stick & Tissue
Kelso, WA 98626 USA

Posts: 11340
*****
 
Just remembered it from doing a few NoCals a couple years back.  My grand-sons loved the NoCals till they learned about tablets and computers!!!
Tom
 

If God is your Co-pilot...switch seats...
Your attitude will determine your altitude!- John Maxwell
And ye shall know the truth, and the truth shall set you free. Jn 8:32
IP Logged
 
Reply #2 - Mar 27th, 2018 at 7:11pm

alfakilo   Offline
Global Moderator
Retired USAF and TWA.
St Louis, MO

Posts: 1133
****
 
You have better luck at finding this stuff than I do! Thanks again very much!

That is a very nice website...lots of goodies to view!
 
IP Logged
 
Reply #1 - Mar 27th, 2018 at 3:44pm

Sky9pilot   Offline
Administrator
Stick & Tissue
Kelso, WA 98626 USA

Posts: 11340
*****
 
Paul and Ralph Bradley have a great site for NoCal's, sheet models printed directly on balsa from inkjet printers, plans, paint schemes printed on tissue and various technical references.  Here's a link to their hot/wet bending balsa for various airplane uses: Click Here  for the site

The article on hot/wet bending balsa can be found here: Click Here
Tom
 

If God is your Co-pilot...switch seats...
Your attitude will determine your altitude!- John Maxwell
And ye shall know the truth, and the truth shall set you free. Jn 8:32
IP Logged
 
Mar 27th, 2018 at 11:09am

alfakilo   Offline
Global Moderator
Retired USAF and TWA.
St Louis, MO

Posts: 1133
****
 
I've seen references to this technique to form wingtips, etc. However, I haven't found much in the way of how to do this.

Does anyone use this method, and if so, how?
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print