Welcome, Guest. Please Login or Register
Stick and Tissue Logo
 
  HomeHelpSearchLoginRegister  
 
 
Pages: 1 2 
Send Topic Print
Speed Merchant - RTP Rubber Speed Model (Read 1405 times)
Reply #2 - Jan 14th, 2019 at 9:26am

strat-o   Offline
Full Member
I Love YaBB 2.5 AE!

Posts: 170
***
 
Interesting.  What are the rules?  Could you make the rolled-tube version push-pull?
 
IP Logged
 
Reply #1 - Jan 14th, 2019 at 8:33am

bigrip74   Offline
Administrator
What did l do this time!
Austin, Texas

Posts: 6092
*****
 
kf, what is the wing span?

Bob
 

IF IT AINT BROKE DONT FIX IT!
IP Logged
 
Jan 13th, 2019 at 3:59pm

Kittyfritters   Offline
Senior Member
Stick & Tissue
California

Posts: 634
****
 
OK, so this is not quite free since it flies around a pole but it still fits here.

Here is the preliminary drawing for The Speed Merchant, my Round-The-Pole rubber powered speed model, for the contest at Duarte on February 16th.  Before I cut wood I'm considering moving the wing to the bottom of the fuselage.  the tether wire will go from the right side of the fuselage, embedded in bottom of the wing about half way between the leading edge and the spar, to the left wing tip where it will have a loop.  Will test both two and four blade prop.  If other obligations permit I will have both the built up fuselage and rolled tube versions ready for test flying at Duarte on January 19.
 

Qua sublata omnia praecepta legis
IP Logged
 
Pages: 1 2 
Send Topic Print