Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Vacuform Tip (Read 573 times)

Stick & Tissue

Posts: 12011
Location: Kelso, WA 98626 USA
Joined: Jan 9th, 2010
Re: Vacuform Tip
Reply #1 - Sep 7th, 2018 at 9:15pm
Print Post  
Alfakilo...nice job and good find!

The height of the box doesn't need to be very high.  Just high enough to accommodate the vacuum hose.  Actually the thinner the height the more effective the vacuum will be.  If you have a bakery or supermarket with a bakery look at the clear plastic boxes for cupcakes, muffins, cookies,etc. Once heated the embossed logos disappear usually.  I get a lot of canopies from these boxes. 

Gotta build me a new vacuum form box soon.

If God is your Co-pilot...switch seats...
Your attitude will determine your altitude!- John Maxwell
And ye shall know the truth, and the truth shall set you free. Jn 8:32
Back to top
IP Logged
Global Moderator

Retired USAF and TWA.

Posts: 1228
Location: St Louis, MO
Joined: Jan 18th, 2018
Vacuform Tip
Sep 7th, 2018 at 1:32pm
Print Post  
While we can make spinners, etc out of colored plastic, we'll probably want clear plastic for canopies. The stuff is expensive and I was stuck with left over plastic that was too small to be used for other projects.

I needed something smaller where I could get more than one object out of a sheet of plastic. I was browsing thru the local Hobby Lobby and found a cheapo (about $3) small wooden box that works great. I mounted it to some scrap wood for stability, drilled some holes in the top, cut out a hole for my ShopVac, and made a plug holder out of a piece of balsa and a screw.

Because it's small, about 5x5, the plug holder needs to be about 1" high, otherwise the plastic sheet will not fit. Here's a pic with a spinner plug attached:


( 49 KB | 29 Downloads )
Back to top
IP Logged
Page Index Toggle Pages: 1
Send TopicPrint