(Moderator: Sky9pilot)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Foamboard Fuselage Jig (Read 497 times)
DanSnow
New Member
*
Offline



Posts: 6
Location: Sacramento CA
Joined: Oct 3rd, 2021
Re: Foamboard Fuselage Jig
Reply #1 - Oct 7th, 2021 at 1:44am
Print Post  
Thank you for the share sky9pilot!

I started doing this about half a dozen models ago after getting a major banana on the first attempt at my Hermiptere. Since then I've been using this approach. Eventually I want to get off my duff and design a fully adjustable one.

The advantage to using the foam is once the model is done, a little trimming and you have a cradle for storage or transport.
  
Curse You, Red Baron!!!!
Back to top
Facebook  
IP Logged
 
Sky9pilot
Administrator
*****
Offline


Stick & Tissue

Posts: 12909
Location: Kelso, WA 98626 USA
Joined: Jan 9th, 2010
Foamboard Fuselage Jig
Oct 1st, 2021 at 4:01pm
Print Post  
Dan Snow on HPA was build a nice sports model and he builds a foamboard jig for his fuselage construction to avoid those bananas we've all experienced.  So as they say, "A picture is worth a thousand words"!

Thanks Dan for a great tool for building fuselages.
  
( 131 KB | 77 Downloads )
foam_fuse_jig_snow.jpg
If God is your Co-pilot...switch seats...
Your attitude will determine your altitude!- John Maxwell
And ye shall know the truth, and the truth shall set you free. Jn 8:32
Back to top
Skype/VoIPFacebook  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

Stick and Tissue Forum » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2023. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge