(Moderators: thymekiller, BillParker, alfakilo, Sky9pilot)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic adjust profile (Read 283 times)
peponio26
New Member
*
Offline


I Love YaBB 2.5 AE!

Posts: 24
Location: Lobos Argentina
Joined: May 21st, 2017
Re: adjust profile
Reply #2 - Sep 30th, 2022 at 4:27pm
Print Post  
Thanks for the comment, I'll keep it in mind.
  
Back to top
 
IP Logged
 
pb_guy
5 Star Member
*****
Offline


So I'm just a kid at heart.

Posts: 2044
Location: Youbou, BC, Vancouver Island
Joined: Oct 15th, 2014
Re: adjust profile
Reply #1 - Sep 29th, 2022 at 4:27pm
Print Post  
Nice looking models! Well done. Personally, I go for the thinnest practical airfoil. Since I almost always use a built-up main spar, I go for a minimum spar thickness of 1/8" (3.2 mm) including the thickness of the top and bottom plates of 1/32" (0.8 mm)
ian
  
Back to top
 
IP Logged
 
peponio26
New Member
*
Offline


I Love YaBB 2.5 AE!

Posts: 24
Location: Lobos Argentina
Joined: May 21st, 2017
adjust profile
Sep 29th, 2022 at 4:13pm
Print Post  
I have been building designed models manufactured in Argentina for some time. Until now, they have been built with a 16-inch wingspan to check their flying conditions. Having verified that some behave well, I want to adjust the flats to the 13-inch peanuts category. My doubt and the question I ask you is related to the thickness of the profile to be used. In this case Clark Y
For you, what would be the most convenient thickness at 10% or 12%.
  
( 132 KB | 37 Downloads )
IMG_20220904_184547199-min_1_.jpg
( 232 KB | 35 Downloads )
DSC_0087-compressed_1_.jpg
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

Stick and Tissue Forum » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2023. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge